This document lists printer specific information for the magicolor 330 printer. It lists the steps necessary for downloading system code version 1.3.1.

Instructions for downloading magicolor 330 system code version 1.3.1.

NOTE:

If the system being updated has a version of code prior to 1.2.1 loaded, the user MUST upgrade to 1.1.2 TB4.0 before upgrading to 1.3.1. The ONLY way this can be avoided is if version 1.3.1 is sent to the printer via parallel after the printer has been rebooted with two keys pressed down and the message 'Download to ser. or par.' has appeared. If the printer is rebooted while pressing two keys and the message 'Download to ser. or par.' has appeared and then 1.3.1 system code is sent to the printer via parallel, the code will update correctly.

To download 1.3.1 system code to the printer the printer must be online and in the idle state. When the printer is Online and Idle, send system code version 1.3.1 to the printer. Once the system code has completed downloading, the printer will reboot and print a start-up page. Check the start-up page to ensure that it shows that the 'System Software Release' is 1.3.1.

If the start-up page does not show that the 'System Software Release' is 1.3.1, the system code did not download correctly. Repeat the download process.