This patch is for UNIX versions of FrameMaker working with the QMS 860
Print System.  The patch must be sent to the printer each time it is
turned on or applied as a Sys/Start file.
  The file fmpatch2.ps should be sent to the printer on each power cycle
if no hard drive is attached.
  If a hard drive _is_ attached, send the fmstart1.ps to the printer, wait
for the hard drive light to stop blinking, then send fmstart2.ps to the
printer.  This will create a Sys/Start file that will run each time the
printer is powered on.  This procedure will also remove any Sys/Start
file that may be previously installed.  If there is already a Sys/Start
file on the attached hard drive, please call QMS Technical Support for
assistance.
  Any questions may be directed to QMS Technical Support.
    Phone: (205)633-4500
    Fax:   (205)633-3716